Post by Jessica on Apr 2, 2010 15:12:01 GMT -5
STEP ONE
Open up a square document, mine is 640 x 640 pixels.
STEP TWO
Go to Filters >> Render >> Clouds >> Solid Noise. Check the Randomize and and Turbulent boxes. Increase the detail level to three or four. Leave the size sliders alone.
Click Okay.
STEP THREE
Now go to Filters >> Render >> Clouds >> Difference Clouds.
Leave the settings alone and click okay.
STEP FOUR
Now go to Colours >> Levels.
Now copy the settings from the image below.
STEP FIVE
Next we add a zoom blur, it's under Filters >> Blur >> Motion Blur.
Now copy the settings from the image below.
STEP SIX
Go to Filters >> Distorts >> Whirl and Pinch. Adjust the whirl angle to around 160, if you want, fool with the other sliders until satisfied
STEP SEVEN
Now duplicate the layer.
STEP EIGHT
Make sure the second layer is selected and click Shift + Control + F. Set the angle close to - 400 this time. Try changing the pinch or radius amount to get a more diverse effect.
STEP NINE
Make sure the second layer is selected, in the layer tab, change the top layer's blend mode to "Lighten Only" and then, right-click and flatten the image or merge down.
STEP TEN
Now we have the pattern, we just need to add the colour, for this, go to Colours >> Curves, now just customize as u wish!
Mine:
And then:
FINISHED PRODUCT
Open up a square document, mine is 640 x 640 pixels.
STEP TWO
Go to Filters >> Render >> Clouds >> Solid Noise. Check the Randomize and and Turbulent boxes. Increase the detail level to three or four. Leave the size sliders alone.
Click Okay.
STEP THREE
Now go to Filters >> Render >> Clouds >> Difference Clouds.
Leave the settings alone and click okay.
STEP FOUR
Now go to Colours >> Levels.
Now copy the settings from the image below.
STEP FIVE
Next we add a zoom blur, it's under Filters >> Blur >> Motion Blur.
Now copy the settings from the image below.
STEP SIX
Go to Filters >> Distorts >> Whirl and Pinch. Adjust the whirl angle to around 160, if you want, fool with the other sliders until satisfied
STEP SEVEN
Now duplicate the layer.
STEP EIGHT
Make sure the second layer is selected and click Shift + Control + F. Set the angle close to - 400 this time. Try changing the pinch or radius amount to get a more diverse effect.
STEP NINE
Make sure the second layer is selected, in the layer tab, change the top layer's blend mode to "Lighten Only" and then, right-click and flatten the image or merge down.
STEP TEN
Now we have the pattern, we just need to add the colour, for this, go to Colours >> Curves, now just customize as u wish!
Mine:
And then:
FINISHED PRODUCT
